Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS5.0 UserChangePassword ?

I've a CACS-1120-K9 with base license , configured dot1x authentication for end-users, but i can't find out how to enable the UCP(UserChangePassword) function as ACS 4.x.

I know ACS5.1 could do this with "acs user-change-password" cmd

BUT , is there other way with ACS5.0 ?

REGARDS

Coast

3 REPLIES
Cisco Employee

Re: ACS5.0 UserChangePassword ?

User Change Password is not supported in 5.0

New Member

Re: ACS5.0 UserChangePassword ?

Cisco Employee

Re: ACS5.0 UserChangePassword ?

You should follow the document . If you have a single ACS server, you should first back up your 5.0 system and then perform steps as described in:

http://www.cisco.com/en/US/partner/docs/net_mgmt/cisco_secure_access_control_system/5.1/installation/guide/csacs_upg.html#wp1167547

351
Views
0
Helpful
3
Replies