Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACSE - Logging into Privileged Mode

I have configured one client, remote agent and the ACSE. I am able to authenticate into the network device via AD. It prompts me for credentials then I am in user mode. I then issue the enable command to enter privileged mode. It then prompts me to authenticate again. My question is how do I configure ACS to enter me directly into privileged mode once I have successfully authenticated? I do not want to first be in user mode then have to authenticate again to enter privileged mode. Any help would be greatly appreciated. Thank You!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ACSE - Logging into Privileged Mode

Bring users/groups in at level 15

1. Go to user or group setup in ACS

2. Drop down to "TACACS+ Settings"

3. Place a check in "Shell (Exec)"

4. Place a check in "Privilege level" and enter "15" in the adjacent field

Also make sure we have exec authorization enabled.

aaa authorization exec default group tacacs+ if-authenticated

Regards,

~JG

Do rate helpful posts

2 REPLIES

Re: ACSE - Logging into Privileged Mode

Bring users/groups in at level 15

1. Go to user or group setup in ACS

2. Drop down to "TACACS+ Settings"

3. Place a check in "Shell (Exec)"

4. Place a check in "Privilege level" and enter "15" in the adjacent field

Also make sure we have exec authorization enabled.

aaa authorization exec default group tacacs+ if-authenticated

Regards,

~JG

Do rate helpful posts

New Member

Re: ACSE - Logging into Privileged Mode

Right on the money! Thanks for your time!

137
Views
4
Helpful
2
Replies