Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Add static route to ACS SE

How can I add a static route to my ACS SE appliance?

I am trying to get AAA working on a Cisco 871 that is a remote end-point of an ASA-to-871 s2s vpn. On the router I am using vlan1 as the source interface for tacacs.

My ACS server sits on my ASA's Management subnet, but the ACS' route back to the remote LAN is via its default gateway and the ASA's INSIDE interface. I need to get the ACS tacacs traffic to return via the ASA management interface.

Thanks in advance.

John

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Add static route to ACS SE

John,

There is no way to set a static route in the ACS appliance. The only network parameters you can set are the ip address/subnet, default gateway, and dns servers.

Regards,

~JG

Please mark it resolved so other can benefit from it

1 REPLY

Re: Add static route to ACS SE

John,

There is no way to set a static route in the ACS appliance. The only network parameters you can set are the ip address/subnet, default gateway, and dns servers.

Regards,

~JG

Please mark it resolved so other can benefit from it

235
Views
0
Helpful
1
Replies
CreatePlease login to create content