Adding Users on Cisco Secure ACS Solution Engine 3.3
We have a large block of userids we need to add to our ACS 3.3 Solution Engine into the CiscoSecure User Database. When using the web-based GUI, it looks like you can only add one user at a time. Is there anyway to add users as a block with some type of command line, or is there a utility that will add users and also copy user options? It would be helpful if in the Add/Edit user panel, there was the ability to copy settings from a previously installed user definition.
Re: Adding Users on Cisco Secure ACS Solution Engine 3.3
I'm not sure that csutil would setup all the parameters I need, so I would have to choose CSDBSync. Tacacs is used and not Radius. I need the user to initially be configured disabled, specify his/her real name and description, assign the user to a group, assign a PAP password and confirmation, use group settings for callback, client ip address assignment, and max sessions, establish a date to automatically disable the account, provide no enable privileges, and set a Tacacs+ Outbound password.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...