I successfully upgraded our ACS SE 3.3.2 to 184.108.40.206. First, I upgraded the SE from 3.3.2 to 3.3.4. After upgrading to 3.3.4, I upgraded it immediately to 220.127.116.11. The upgrade was successful. However, the login page still displays 3.3 and the Home page still displays 3.3.12. Even the menus are for 3.3 version. When I checked the Appliance Upgrade Status page, it displays 18.104.22.168 as the Cisco Secure ACS. What do I need to do? We also have a 22.214.171.124 ACS 1113 SE but this one doesn't look like the upgraded one.
I have the installer of the 4.1.1. Can I install that one in the 126.96.36.199 appliance then upgrade again to 188.8.131.52? Thank you very much for your reply. How can I downgrade this 184.108.40.206 to 220.127.116.11? Thanks.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...