Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

After Windows 7 fails 802.1X on wired network

Hi, I'm testing flex-auth and fail-open which is critical vlan.

when I FAIL(not timeout) to 802.1X authenticate, it is not getting IP address even though the switch initiates MAB.

What I want to do is provisioning 802.1X from ISE and using it.

so flow is like this :

1. the supplicat (windows7) connects to the network.

2. Switch and supplicant tried 802.1X but the 802.1X is not set up on windows 7 so it goes to MAB and I am able to open the ise guest portal.

3. login with ad credential, and install wired 802.1x.

4. reconnect to swith and try 802.1x authentication but I put wrong ID/PW

5. after few times of miss entering ID/PW, I could not get IP from DHCP.

6. verified on SW see if MAB is initiated, and yes. but could not get IP address on windows 7.

does anyone know why ?

200
Views
0
Helpful
0
Replies