Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

applying service policy using radius and VPDN

anyone had any success doing this?

I've been following the suggested config at but not having any success.

sessions terminate on my 7301 via L2TP through another provider - this all works fine.

I have the following AVPair defined in the user RADIUS profile:

Cisco-AVPair = "ip:sub-qos-policy-out=DROP-P2P"

and the matching policy map defined on the 7301 but it does not get applied to the user session.

Debug L2X errors gives the following message:

001867: Oct 30 16:12:50.655 UTC: L2X: Unknown AVP 76 in CM SCCRQ

001868: Oct 30 16:12:50.655 UTC: L2X: Ignoring unknown AVP 76

if I apply the policy map in the virtual-template it does get applied, but obviously to all users on that template which is not what I want.

edit: - btw the 7301 is on 12.4 so this feature should be available.




Re: applying service policy using radius and VPDN

With a router it won't be possible to get different policy for users in a single template. Following link may help you

New Member

Re: applying service policy using radius and VPDN

thats the same document I referenced in my original question and its states clearly "You can choose to configure the feature using either a virtual template or a RADIUS server."

If you add the policy to the virtual template it will apply to all users, if you use RADIUS you (should) be able to apply policies on a user-by-user basis.

CreatePlease to create content