Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AS5300 Accounting - persistance of Radius stop/start reports

If connection to our accounting Radius server becomes unavailable for a time, how long will our AS5300 continue trying to send start/stop messages to it?

We have tested other competing access server products which seem to retain this information almost indefinitly until the Radius becomes available, so we hope that our AS5300 will perform similarly.

  • AAA Identity and NAC
2 REPLIES
Cisco Employee

Re: AS5300 Accounting - persistance of Radius stop/start reports

You would set this with a couple of commands in the AS5300.

> radius-server retransmit

> radius-server timeout

Defaults are 3 and 5 respectively, so it'll try 3 times to send the packet with a time of 5 seconds in between each one before it gives up.

New Member

Re: AS5300 Accounting - persistance of Radius stop/start reports

Hi Glenn,

The radius attribute 195 (Disconnect Cause) by Ascend, in which part of the radius packet is this attribute present?, when a Cisco NAS send accounting information to a Radius Server.

Thanks a lot,

Jorge.

128
Views
0
Helpful
2
Replies