Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5510 strange behavior when move server to DMZ

I begin setup ASA 5510 and create DMZ, succesfull add our proxy to DMZ and all works fine, now i want to add one more server to DMZ.

I add NAT and set our free external ip to it all works fine, but when i turn off networks cable from server, left only DMZ link and use it with NAT all stop working! I can ping DMZ gateway, but cant access internet :(

I attach my config to this post.

I am new to cisco devices, and suspect there may be some protection from IP address change or kinda, but cant figure out what wrong :(

Everyone's tags (6)
3 REPLIES
New Member

skyranger9999,I think no

skyranger9999,

I think no access-list permitting 192.168.1.4 from dmz to outside.

 

Always rate helpfull posts

Sajid Ali Pathan

New Member

192.168.1.4 works fine it 192

192.168.1.4 works fine it 192.168.1.5 i have problems, but when i setup temporary any to nay globally it still did not work so it not ACL problem :(

New Member

I move 1 more of my server to

I move 1 more of my server to DMZ after i run on it 'arp -d *' and reboot, but other server i still have this problem, when i set in NAT x.x.x.201 external ip it stops ping out sites and only ping DMZ, but when i change ip to free external in x.x.x.205 all begin works.

 

Prblem is there mail server and there DNS records i did not whant to change :(

149
Views
0
Helpful
3
Replies
CreatePlease login to create content