Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

aup+device registration

Hi All,

The requirement is to have a corporate user go through the guest portal to register the device and accept the AUP to get full access. We tested with a guest portal with AUP enabled but device registration page desent appear and once AUP is accepted because the device is not registered it dosent go to the next authz rule to get full access. We want to avoid the self provisioning flow because network assistance wizards are not necessary.When self provisioning is enabled device registration page appears and then download of the setup wizards and for some reason AUP doesnt show in the portal page.

how do we enable device registration only with AUP accept page during the on boarding without any network assistance getting downloaded?

Thanks

2 REPLIES
Cisco Employee

aup+device registration

Implementing an Acceptable Use Policy for Employees

You can require employees to acknowledge an acceptable use policy when using the My Devices portal.

Customizing the Acceptable Use Policy for Employees

If  you require employees to acknowledge an acceptable use policy, you must  update the templates to reflect your company's policy.


Step 1 Choose Administration > Web Portal Management > Settings > My Devices > Language Template.

Step 2 Click the language for which you want to apply the policy.

Step 3 Click Configure Acceptable Use Policy Page and update the title and text to follow your company's policy.

Step 4 Click Save.

New Member

aup+device registration

Hi

Thanks for the feedback.

In mydevice portal user has to manually enter device mac to register the device.Can we do without mydevice portal just by using the guest portal? for example,

multiportal config->enable portal-> self provision flow is not checked, only aup is checked. When user connects,

authz rule 1, peap->redirects the user to guest portal to do cwa, user accepts the aup, retry the original page message appears.

authz rule 2, registered device+peap->full access

Because the guest portal dosent have a device registration page (which automatically populates the MAC) ise always put the user to rule 1 again and not allowing full access,

Tks

201
Views
0
Helpful
2
Replies
CreatePlease login to create content