authenticate cisco WLC 5508 with cisco ACS 1120 (Ver 5.0) using TACACS+
My setup has cisco WLC 5508 & ACS 1120 ver 5.0. How do i authenticate users who access the WLC via the ACS 1120 that users TACACS+. I am able to authenticate users for cisco routers and switches, but when I try to same for WCL, it fails.
Can someone please explain the basic config/steps that needs to be configured on both WLC & ACS.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...