I had deployed a L3 Virtual Gateway mode for NAC appliance. There is ACS for authentication. How can I add ACS to "Auth Servers". CAM settings do not need mapping rules. Every user just anthenticate oneself's account, then CAM can pass these info to ACS. What should I do, Thank you?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...