Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

authorization popup

Hi,

I installed ACS 3.1 in our lab for testing. I configured pix so that all users going from inside pix network to ouside gets authenticated.

I am facing some problem when accesing internet.

Some times it pops so many windows for authentication. For cisco site itself i put username and password 3 times.

How can i limit this. i want users authenticate just once instead of 3 4 times. i read that virtual http config in pix will do. But its configured for outside to inside . What if the trafic is inside to outside .

Is there any site from where i can find sample config of acs ( like device management , giving rights for each admins to monitor specific devices). I am really new to acs.

Thanks

1 REPLY
Cisco Employee

Re: authorization popup

Here is the link which has config and troubleshooting for "Virtual HTTP for Outbound" which is for the traffic from inbound to outbound.

http://www.cisco.com/warp/customer/110/atp52.html#virtual_http

Hope that helps.

274
Views
0
Helpful
1
Replies
CreatePlease to create content