I created a Full Back Up On Demand job on the adm-node under Administration -> Maintenance -> Monitoring Node -> Full Back Up On Demand.
Start Time of the job is 2013-07-03 and still running.
I did a reload of the primary adm-node and a message was displayed that a backup job was running with the question would you like to stop it (something like that). But when de adm-node came back up the job was/is still running.
The backup repositary is a remote server (FTP). The status of the backup on the ISE UI is 'Running'
From where I want to delete? Don't know... That's my question ;-)
I got it. I think, the backup process is not running actually and it just stuck in the status update process on application level. I understand what you're talking about, there is a warning message comes up on the CLI screen when you issue a reload command because reload by-deafult hault the backup/restore process. This can be easily verified by running a command on the CLI
show backup history in the EXEC mode.
On the FTP repository, you may also check if the backup size is increasing in the directory you've selected.
If you want to delete the backup from repository then these are the steps
Step 1 Choose Administration > System > Maintenance. Step 2 From the Operations navigation pane on the left, click Repository. The repositories listing page appears. Step 3 Click the radio button next to the repository that you want to delete, then click Delete. Cisco ISE prompts you with the following message: Are you sure you want to delete this repository? Step 4 Click OK to delete the repository. The following message appears: Repository was deleted successfully. The Repository List page appears and the repository that you deleted will no longer be listed in this page
DocumentationCode download linksGoalRequirementLimitationsSupported ISR
and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity
options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in
HA DocumentationCode download linksGoalRequirementLimitationsSupported
ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationCo...
Question I am currently unable to specify "crypto keyring" command when
configuring VPN connection on my cisco 2901 router. The following
licenses have been activated on my router :