Once you're done with initial configuration on the offline box ( thatt includes hostname, ip-address, domain name etc) then connect you machine/laptop and assign your machine same range ip address so that they can communicate. Once it's up then establish an SSH connection and restore the back'd up file to the offline ACS box.
Make sure we create repository with FTP protocol (for avoiding any issues) and the same repository should be configured on your machine connected to ACS.
did the below does the same and save the config to an ftp server than restored back to the offline box after the inital config???
Note If you do not save the running configuration, you will lose all your configuration changes during the next reboot of the ACS server. Once you are satisfied that the current configuration is correct, copy your configuration to the startup configuration with the preceding command.
copy startup-configuration running-configuration
Copies the startup configuration to the running configuration. Merges the startup configuration on top of the running configuration.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...