Cisco ISE user guide suggests that all 4 ports can be assigned IP addresses and that's that. No suggestions such as if the all ports should be on different VLANs or if the ports can be bundled, hence saving IP address space. I have read the book by ISE expert Aaron Woland and no suggestions either.
On a Standalone ISE, as soon as I configured Gi1 with a different IP subnet from Gi0, I lost GUI access. So my questions are as follows:
1. Can all 4 ports be bundled
2. If no bundling and all 4 ports are assigned IP addresses, can they be on different IP subnets, whether Standalone or Distributed personas. For example a PSN with 4 ports. Gi0 - 10.0.10.x, Gi1 - 172.16.5.x, Gi2 - 172.16.8.x, Gi - 10.2.5.x
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...