Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CAM CAS "connected" but cannot open CAS webpage on https ????

I am confused.

Yes. I have CAM CAS connected !  and certs looks fine. I have rebooted CAS and CAM both , and can ping eachother,  and do ssh to both of them as well, even did service perfigo stop and then start, yet  CAM gies me GUI  on https  but  CAS is not giving me https ????

Experts, please advice me some troubleshooting steps. Tired .....

"there is no firewall blocking any ports whatsoever"

awaiting inputs from the globe....

2 REPLIES

CAM CAS "connected" but cannot open CAS webpage on https ????

Hi,

What version of CAS are you running, also what browser are you using? Also are you on the same subnet as the CAS' ip address and is the CAS in virtual gateway?

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
New Member

CAM CAS "connected" but cannot open CAS webpage on https ????

This is resolved. it was not NAC issue, rather in WLC some setting was wrong.

thanks anways.

regards,

135
Views
5
Helpful
2
Replies
CreatePlease to create content