Can I default the Admin account of an ACS SE without a recovery CD
Hi - I have an ACS soultion engine 1111. I've been using it mess around with but now need to return it to stock so need to default it and get rid of the admin account. A TAC engineer has told me I can do this from the CLI but hasn't said exactly how.
Is it possible to return the device to factory defaults from the CLI or do I have to get hold of a recovery CD? The device is running 4.1
Re: Can I default the Admin account of an ACS SE without a recov
Hi JG - Thanks for taking the time to reply.
However I don't think you understand the problem either;
I have the Admin account username
I have the Admin account password
I have the DB password
I have console access
What I need to do is for the unit to boot and to be able to log into the device using 'Administrator' and 'setup' which is how the device comes from the factory. This is because I am putting this device back into stock and the next engineer won't know the passwords that I have set - I need to default the unit, not change the passwords.
Is this possible from the command line or do I need a recovery CD?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...