Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can't activate radius or tacacs+ on Cisco 801

Hello,

I have some Cisco 801 with IOS:

- C800-Y6-MW.121-3.XG4

- C800-G3-MW.120-3.T1

when configuring them, after issuing -aaa new model-,

the command -aaa authentication login default ?- shows you:

enable

line

local

local-case

none

but not the options radius neither tacacs+.

I haven't found any but related with this issue.

P.D. In a Cisco 803 with a 12.1(2)T it works perfectly

1 REPLY
Cisco Employee

Re: Can't activate radius or tacacs+ on Cisco 801

The Feature Navigator (http://www.cisco.com/cgi-bin/Support/FeatureNav/FN.pl) shows that TACACS wasn't supported in the 801 series until 12.1(2)T at the earliest. No 12.0 code has this feature in it.

Similar with Radius support.

273
Views
0
Helpful
1
Replies