Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot access web admin CSACS 1113 appliance

Im trying to configure new 1113 appliance, but I cannot access web admin. I can access it from telnet using administrator login, but when I try administrator login on web admin login page, it failed.

Any idea what happen to my appliance?

Thx

9 REPLIES
New Member

Re: Cannot access web admin CSACS 1113 appliance

i'm having a similar problem though i can't telnet to the box

how did you you configure it for telnet/ssh access

watch my post & hopefully it may generate a solution

New Member

Re: Cannot access web admin CSACS 1113 appliance

Have you configure it using serial connection? For initial configuration, you need to console the box. Then, you must change default administrator login and set the ip address of the box. No other configuration needed for telnet access.

New Member

Re: Cannot access web admin CSACS 1113 appliance

Problem solved.

1113 appliance cannot have same hostname and admin name.

khu
New Member

Re: Cannot access web admin CSACS 1113 appliance

I have the same problem, can telnet to the 1113 but web access hang when try to connect to http://ip:2002/

New Member

Re: Cannot access web admin CSACS 1113 appliance

apologies on hijacking this thread but i can't seem to get into the box.I've consoled into the device but nothing is showing up on the screen..really odd!

New Member

Re: Cannot access web admin CSACS 1113 appliance

are you sure you're using the correct settings in hyperterminal?

hope this helps

New Member

Re: Cannot access web admin CSACS 1113 appliance

I use SecureCRT and i've used the same settings for all of the cisco devices with no problem. I'm just puzzled on why i can't console in...urgh, frustrating!

New Member

Re: Cannot access web admin CSACS 1113 appliance

Check the settings for the terminal software connected to the console.

The settings are :

.Baud = 115200

.Databits = 8

.Parity = N

.Stops = 1

.Flow control = None

From ACS 4.1 , the appliance administrator cannot login through ACS GUI. We need to create a GUI admin for accessing acs web interface.

khu
New Member

Re: Cannot access web admin CSACS 1113 appliance

mine is working now after a reboot.

399
Views
0
Helpful
9
Replies
CreatePlease login to create content