Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cannot Add Cisco NAC CAS to CAM

Hello,

 

both server are working ok and they can ping each other, but when I try to add CAS into CAM it says:

Failed to add server: Could not connect to 10.10.20.100    

 

Any idea what this problem could be?

 

Regards,

5 REPLIES

Which mode are you trying to

Which mode are you trying to add CAS in?

Also, what VLANS are they on?

trusted VLAN i mean (eth0)

Rate if Useful :)

Sharing knowledge makes you Immortal.

Regards,

Ed

New Member

OOB modethe CAM in VLAN10both

OOB mode

the CAM in VLAN10

both CAS interface are in VLAN20

Is it VGW or Real-IP? Ed

Is it VGW or Real-IP?

 

Ed

New Member

it's VGW, I'm using

it's VGW, I'm using evaluation Lic, as described by cisco it allows you to use one CAS server, for one month.

I reinstalled the servers, reconfigured them, nothing working!

is there any config I have to do in the CAS to successfully added it into CAM?

 

Regards,

 

Could you turn on trace on

Could you turn on trace on CAS and CAM and share the logs?

http://www.cisco.com/c/en/us/td/docs/security/nac/appliance/configuration_guide/45/cam/45cam-book/m_admin.html#wp1161914

http://www.cisco.com/c/en/us/td/docs/security/nac/appliance/configuration_guide/48/cas/48cas-book/s_admin.html#wp1041372

try re-adding once before starting the log collection.

Rate if Useful :)

Sharing knowledge makes you Immortal.

Regards,

Ed

61
Views
0
Helpful
5
Replies
CreatePlease to create content