I cannot disable DHCP on a Cisco Secure ACS. I am consoled into the device and run "set ip", choose "yes" for static IP and enter my IP information. However, after save, network test, etc... DHCP is still enabled and grabs an address on reboot. Anyone seen this or have ideas???
Hi, I had a similar problem on the Appliance (Ver 4.00). After the initial configuration I had to reboot and then re-enter both the IP and hostname. You also have to make sure that when you set up initially that the device is connected to the network. The re-entering the IP address was a TAC recommendation. Hope this helps.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...