Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cascade a switch to a dot1x port

Need help.. I'm trying to cascade a un-managed switch to a parent swith with a dot1x enabled port. IOS Ver of both switches (slave & parent ) are dot1x compliant.

Config Settings of my Parent switch:

dot1x system-auth-control

dot1x guest-vlan supplicant

int f0/15

switchport mode access

dot1x port-control auto

dot1x host-mode multi-host

dot1x timeout quiet-period 3

dot1x timeout tx-period 15

dot1x max-req 5

spanning-tree portfast

No configuration is set on my slave switch because I want to do a straightforward cascade. Is it possible ?

Thanks...

1 REPLY
Silver

Re: Cascade a switch to a dot1x port

I am not sure if this is possible. If you are connecting two switches, then the ports need to be trunk ports. Right? I guess dot1.x will work on the access ports only. Anyone any comments?

227
Views
0
Helpful
1
Replies