The only way i can get an account to work is if i Telnet before i SSH to the ACE device? ANy help would be great as the ACE links stright into to a Firewall hence i'm gona find this hard to do for 40 odd users....
Also why does the CONF T only work if i use the following in the user account setup and not in the group. This will be a huge pain as i will have to amend all the accounts by hand one by one!????
Re: Cisco ACE and ACS setup - why u need to telnet 1st before SS
Regarding your ACS question, the presence of any user specific attributes will make ACS ignore any group level attributes for that user. There is no way to combine attributes at both user and group levels.
Regarding bug CSCsu36078, what firmware version are you running on your ACE?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...