Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco ACS 3.1 and Logging CLI commands from Nortel Passport

Good Afternoon,

We are trying to log CLI commands to Cisco ACS version 3.1 from Nortel Passport 8600's. The version of code running on passports does not support tacacs+.

The Passports authenticate okay but do not log any command information. I "think" the problem may be that the Radius Nortel VSA for cli-commands-attribute, 195, is not being collected by ACS.

Does anyone know how I would go about getting this VSA added in to the existing Radius(Nortel) list?

Many thanks,

Regards,

Flett.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Cisco ACS 3.1 and Logging CLI commands from Nortel Passport

Flett,

You need to add Nortel attribute 193-195 to enable command accounting.

Unfortunately you cannot upload it on 3.x code, so you need to upgrade acs to 4.x code.

Regards,

~JG

Do rate helpful posts

4 REPLIES

Re: Cisco ACS 3.1 and Logging CLI commands from Nortel Passport

Flett,

You need to add Nortel attribute 193-195 to enable command accounting.

Unfortunately you cannot upload it on 3.x code, so you need to upgrade acs to 4.x code.

Regards,

~JG

Do rate helpful posts

New Member

Re: Cisco ACS 3.1 and Logging CLI commands from Nortel Passport

Thanks very much for your help JG.

Do you know if it is an easy thing to do on ACS 4.x?

Regards,

Flett.

Re: Cisco ACS 3.1 and Logging CLI commands from Nortel Passport

Yes, it is quite simple to upload the VSA. Find attached the steps to upload it.

Regards,

~JG

New Member

Re: Cisco ACS 3.1 and Logging CLI commands from Nortel Passport

Thanks once again JG

566
Views
5
Helpful
4
Replies
CreatePlease to create content