Go to Cisco.com > Products > Security > Identity Management > Cisco Secure Access Control System > Cisco Secure Access Control System 5.1 > Secure Access Control System Software-220.127.116.11 > Download "ACS_v18.104.22.168.iso"
You need to install the .iso file as described on the attached .pdf document.
After properly installing the ACS 5.1 as described on the .pdf you can generate an Evaluation License as described on the other .pdf document.
Thanks for helping. Now VPN is working through ACS. But I have a little problem. I have 2 VPN profile and 2 AD Group. for example I gave access for Admins VPN profile only for Admin-users group in AD and Test VPN profile for test-users ind AD group. But all my AD users Can access both of these vpn profile . How I can put deny access that only Admin-sers can access Admins VPN profile and test-users group can access only Test VPN profile. I put screenshorts about my rules.
And I have another problem, I changed last rule to default deny access. but I have 2 access rule to two VPN profile. When for example Admins-VPN is above than TEST-vpn it's working but when it is in the below it's now working why?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...