I have created a command autherization set for denying the below commands .
and it is working fine in all devices except some SCE devices .
In SCE device ,when you enter "configure" ,its not working .but if enter "conf t " or "con" its allowing to go to config mode ,similar for debug,reload commands too .when you are typing exact command mentioned in command set ,its not working .but when type some key words its working fine .
This command set applied to lots of other devices too ,and its working properly .
Please advice me how i will how i will prevent the abouve commands to these SCE devices .
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...