Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco ACS 5.5 username and password

Hi All

 

I have defined username and password for one of the users to login to the routers.

I have set the password.

 

Can please advise how do I make him change the password after his first login with the given username and password.

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

While creating a user under

While creating a user under Users and Identity Stores > Internal Identity Store > Users > createe. Check this box to start the process to change the user’s password at the next user login, after authentication with the old password.

http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_secure_access_control_system/5-5/user/guide/acsuserguide/users_id_stores.html#49082

 

Regards,

Jatin Katyal

*Do rate helpful posts*

~BR Jatin Katyal **Do rate helpful posts**
3 REPLIES
Cisco Employee

While creating a user under

While creating a user under Users and Identity Stores > Internal Identity Store > Users > createe. Check this box to start the process to change the user’s password at the next user login, after authentication with the old password.

http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_secure_access_control_system/5-5/user/guide/acsuserguide/users_id_stores.html#49082

 

Regards,

Jatin Katyal

*Do rate helpful posts*

~BR Jatin Katyal **Do rate helpful posts**
New Member

Hi Jatin Katyal, Thanks. I am

Hi Jatin Katyal,

 

Thanks. I am aware of this. But not sure how it works.

Say customer used this username and password for the first time to login to the router. It will prompt to change the password? Please advise

 

Thanks

Cisco Employee

That's correct! when an

That's correct! when an internal user successfully authenticates very first time with an administrator created password via telnet/ssh, the user will be prompted to change/reset the password (as per the password management policy for an internal user) on the same screen.

 

Regards,

Jatin Katyal

*Do rate helpful posts*

~BR Jatin Katyal **Do rate helpful posts**
50
Views
5
Helpful
3
Replies