Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco ISE 1.2 AD Integration Error

Hello,

I have a fresh install of Cisco 1.2.0.899 on a VM. I cant seem to join it to the Active Directory. It gives a message that says "Cannot Reach ISE Node" in the section where its supposed to show "Not Joined to the Domain".  On further Examination i also noticed that i cannot download logs. it gives me an error that reads "Cannot Reach ISE Node".

Can someone please tell me what could be the possible cause of this error and how it can be resolved.

I have licences already installed added on the ISE Node. Re-imaging it will not be a good idea i guess.

Thanks

Ibrahim Kabir

3 REPLIES
Community Member

Re: Cisco ISE 1.2 AD Integration Error

Hi Ibrahim,

If seen this in my lab as well. In my lab it was because the VM was defined as linux 32 bit instead of the required red hat enterprise linux 5 (64 bit). Please check http://www.cisco.com/en/US/docs/security/ise/1.2/installation_guide/ise_vmware.html to verify your VM.

Sent from Cisco Technical Support iPhone App

Cisco Employee

Re: Cisco ISE 1.2 AD Integration Error

I'd like to confirm if the required changes in the VM server were

made, as there are a few changes in the ISE OS. The changes required are

listed in the release notes, under "VMware Operating System to be

Changed to RHEL 5 (64-bit)". Here's a direct link to the relevant section:

http://www.cisco.com/en/US/docs/security/ise/1.2/release_notes/ise12_rn.html#wp384531

Other causes can be :-

certificate issue on ISE or not enough disk space.

Bronze

Cisco ISE 1.2 AD Integration Error

Please  check the below links which may be helpful for you:

Link-1

http://www.cisco.com/en/US/docs/security/ise/1.2/user_guide/ise_man_id_stores.html

399
Views
0
Helpful
3
Replies
CreatePlease to create content