Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco ISE 1.2 - NFS Backup

I'm trying to use NFS to backup Cisco ISE on a schedule but I'm having difficulty.  I'm not sure what the settings should be or the proper syntax.          

5 REPLIES
Cisco Employee

Cisco ISE 1.2 - NFS Backup

Was this ever worked for you? If yes, Is your deployment an upgrade from 1.1.x?

Could you please provide me the "Show run" and "Show timezone" from the ISE CLI.

~BR
Jatin Katyal

**Do rate helpful posts**

~BR Jatin Katyal **Do rate helpful posts**
Silver

Cisco ISE 1.2 - NFS Backup

Hello,

please go through the link below :-

http://www.cisco.com/en/US/docs/security/ise/1.2/cli_ref_guide/ise_cli_app_a.html#wp1027894

the syntax example :-

backup-staging-url nfs://loc-filer02a:/vol

nfs:

Source or destination URL for an NFS network server. Use url nfs://server:path1.

Server is the server name and path refers to  /subdir/subsubdir. Remember that a colon (:) is required after the  server for an NFS network server.

New Member

Cisco ISE 1.2 - NFS Backup

Hello David,

Please share your ISE running configuration to find and verify syntex.

Source or destination URL for an NFS network server. Use url nfs://server:path1.

Server is the server name and path refers to /subdir/subsubdir. Remember that a colon (:) is required after the server for an NFS network server.

Also please reverify below required format:

The path must be valid and must exist at the time you create the repository. The following three fields are required depending on the protocol that you have chosen.

–ServerName—(Required for TFTP, HTTP, HTTPS, FTP, SFTP, and NFS) Enter the hostname or IPv4 address of the server where you want to create the repository.

–Username—(Required for FTP, SFTP, and NFS) Enter the username that has write permission to the specified server. Only alphanumeric characters are allowed.

–Password—(Required for FTP, SFTP, and NFS) Enter the password that will be used to access the specified server. Passwords can consist of the following characters: 0 through 9, a through z, A through Z, -, ., |, @, #,$, %, ^, &, *, (, ), +, and =.

Cisco Employee

Cisco ISE 1.2 - NFS Backup

Cisco ISE 1.2 - NFS Backup

If you are doing this from the gui, the : should be automagically appear. Just enter the hostname or ip address in the server field follow by the path in the next field.

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
1542
Views
0
Helpful
5
Replies
CreatePlease to create content