Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cisco ISE - Not use FQDN in url-redirect parameter

Hi,

I am using Cisco ISE Central Web Authentication for Guest Wireless. Clients are redirected for web authentication to: https://ip:port/guestportal/gateway?sessionId=SessionIdValue&action=cwa as it is specified by the url-redirect parameter in the Authorization Profile.

The “ip” field in the url is now replaced by the FQDN of the Cisco ISE, but I want to use the IP address instead of the FQDN. Is there any way to do that?

As far as I know in version 1.2 you can use the “ip host/no ip host” command to indicate what you want to use in the URL. However my Cisco ISE is running version 1.1.1.268.

Thank you very much.

Joana.

2 REPLIES
New Member

Cisco ISE - Not use FQDN in url-redirect parameter

Available in 1.2, and available as a "bit of a bodge" in 1.1.x  (read "a lot of a bodge")

If you only have one PSN then you may be able to get it to work, but after that you lose the ability to get the session to be pointed automatically at whichever PSN they hit initially so it would break.

Copy the settings that are applied when you use CWA, then create your own based on the same settings but using the ip address pasted in there instead.

New Member

Cisco ISE - Not use FQDN in url-redirect parameter

Hi,

Thanks for the clarification. I think my best option is going for the upgrade to version 1.2 then.

Joana.

346
Views
0
Helpful
2
Replies
CreatePlease to create content