Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cisco Secure ACS 5.1 in HA Mode

Hi team,


we have setup of two appliances of Cisco Secure ACS. We need to implement in HA mode both.


We have register secondary with primary. But when primary goes offline then not able to view logs on secondary. Able to authenticate with devices.



How we will manage logs on Both appliance.



Regards

Milind Rane

3 REPLIES

Re: Cisco Secure ACS 5.1 in HA Mode

Hi Milind,

It seems you have not defined log server log server. In a distributed deployment, you should designate one of the secondary ACS

servers  as the Monitoring and Reports server,  and specify that it receive the logs from all servers in the deployment.  By default, a Log Target called the LogCollector identifies the Monitoring and Reports server. In cases where a  distributed deployment is used, the Log Collector option on the web  interface designates which server collects the log information.



It is  recommended that you designate a secondary server within the deployment  to act as the Monitoring and Reports server.

Regards,

~JG


Do  rate helpful posts


New Member

Re: Cisco Secure ACS 5.1 in HA Mode

Hi Jagdeep,

what happens when the secondary appliance goes down, which is defined as log target? Then I can't access the logging and monitoring too.

Regards,

Michael

New Member

Re: Cisco Secure ACS 5.1 in HA Mode

Same problem here.....Any solution? .. I lost logging when the secondary server (LogCollector) go down.

Regards

1772
Views
0
Helpful
3
Replies
CreatePlease to create content