Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Combining Default ACLs with Radius assigned ACLs in L2TP

Hi there,

is it possible to assign an ACL defined by Radius and at the same time the LNS combine the use of this ACL with the default ACL defined in the Virtual-Template?

I've checked following instructions on this cisco document but what I can see is that ACL asssigned by Radius deactivates the defeault ACL existing in router config defined in virtual-template... even when defined one as IN and the other in OUT.


Do you know any way to combine usage of both? One for general security control and the other for specific usage limitations...

Everyone's tags (5)
1 REPLY
New Member

Re: Combining Default ACLs with Radius assigned ACLs in L2TP

Sorry, this was the original document by Cisco I've been cheching: How to Apply Access Lists to Dial Interfaces with a RADIUS Server

413
Views
0
Helpful
1
Replies