Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

Command Authen - All CLI and selected Enable

CiscoSecure ACS 3.2 - I want to give selected users:

- unlimited access to all CLI command set

- enable access but only to selected commands

I'd prefer not to have to visit each router but do want the same control if the TACACS system is unavailable

  • AAA Identity and NAC
1 REPLY
Silver

Re: Command Authen - All CLI and selected Enable

The authorization command causes a request packet containing a series of AV pairs to be sent to the RADIUS or TACACS daemon as part of the authorization process. The daemon can do one of the following:

Accept the request as is.

Make changes to the request.

Refuse the request and refuse authorization. I am not sure nd it also doesn't talk about creating a request.

98
Views
0
Helpful
1
Replies