Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Command Authorization Config best practice using ACS

Hi

Is there any best practices for configuring Command authorization (for router/switch/asa) in CS-ACS? To be specific, is there any best practices to configure authorization for a set of commands allowed for L1,L2,L3 support levels?

Regards

V Vinodh.

1 REPLY

Re: Command Authorization Config best practice using ACS

Vinodh,

The main thing here is to ensure that we have backup/fall-back method configured for command authorization, inorder to avoid lockout situation or do wr mem once you are sure configs are working fine.

Please check this link,

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00808d9138.shtml

Regards,

~JG

Do rate helpful posts

206
Views
0
Helpful
1
Replies
CreatePlease to create content