Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Command authorization failed - PIX 506e

i used following commands on PIX 506e

#username xxxx password xxxx

#aaa authentication telnet console LOCAL

#aaa authentication enable console LOCAL

#aaa authorization command LOCAL

now when i reboot after saving to flash memory..i am getting screen wherein I type username and password. When i get into prompt, i am not able to execute any commands. It gives error

#Command authorization failed

Does anyone know how do I get my PIX back..even password recovery through TFTP is not working.

1 REPLY
New Member

Re: Command authorization failed - PIX 506e

Go to Interface Configuration > Advanced TACACS+ Settings.

Check Advanced TACACS+ Features in Advanced Configuration Options and click Submit. This will make the Advanced TACACS+ Settings visible under the user configuration.

Under IOS authorization permit all unmatched commands on the ACS and also permit all attributes. Also make sure shell (exec) is enabled and priviledge level is 15 for the user

472
Views
0
Helpful
1
Replies
CreatePlease login to create content