I have followed the document to a tee but when I log in with my test2 user account it gives me user mode access only (> prompt) instead of Priv Exec (# prompt) but with only show command privileges! I guess this is because I am specifying level 1 access but that's what the doc says to do.......
My config is as follows:
Cisco 2811 Router
aaa authentication login defaut group tacacs+ local
aaa authentication enable default group tacacs+ enable
aaa authorization config-commands
aaa authorization exec default group tacacs+ local
aaa authorization commands 1 default group tacacs+ local
aaa authorization commands 15 default group tacacs+ local
aaa session-id common
ACS 4.2 Config
Shell Command Authorization Set: Name = ReadOnlyAccess - Unmatched commands set to Deny, with the show command configured in the box below and I have checked the Permit Unmatched Args check box next to it
User: Test2 in UserGroup: ReadOnlyGroup with Enable options - Max Priv for any AAA Client: Level 1, TACACS+ - Shell (exec) box checked and Priv level checked and set to 1
Shell Command Authorisation Set - Assign a Shell Command Authorization Set for any network Device radio button selected specifying ReadOnlyAccess as the Command authorisation set to apply.
Command Authorization Set Show Run Permissions Only
I have resolved this issue by giving my Test2 User account Priv 15 access and then specifying the commands that can be permitted within the command authorisation set applied to all devices, which is the way I thought it should be done in the first place
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...