07-21-2008 08:25 AM - edited 03-10-2019 03:59 PM
Hi!
We use a Cisco Secure ACS Solution Engine, running V4.2.0.124.3.
The Appliance hast two Ethernet Ports.
- We need to know how to configure an IP-Adress on the second port. But more:
- We need to know how to configure static IP-routes on this device.
Is anyone out there to tell us how to do it ?
Regards, Markus
Solved! Go to Solution.
07-21-2008 09:32 AM
Markus,
In acs you can only use one NIC and there is no way you can set static routes on it.
Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors. Each Ethernet connector provides all the functions of a network expansion card and supports the 10BASE-T, 100BASE-TX, and 1000BASE-TX Ethernet standards.
Each NIC is configured to automatically detect the speed and duplex mode of the network.
Regards,
~JG
Do rate helpful posts
07-21-2008 09:32 AM
Markus,
In acs you can only use one NIC and there is no way you can set static routes on it.
Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors. Each Ethernet connector provides all the functions of a network expansion card and supports the 10BASE-T, 100BASE-TX, and 1000BASE-TX Ethernet standards.
Each NIC is configured to automatically detect the speed and duplex mode of the network.
Regards,
~JG
Do rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: