Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure static ip routes on CS ACS-SE

Hi!

We use a Cisco Secure ACS Solution Engine, running V4.2.0.124.3.

The Appliance hast two Ethernet Ports.

- We need to know how to configure an IP-Adress on the second port. But more:

- We need to know how to configure static IP-routes on this device.

Is anyone out there to tell us how to do it ?

Regards, Markus

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Configure static ip routes on CS ACS-SE

Markus,

In acs you can only use one NIC and there is no way you can set static routes on it.

Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors. Each Ethernet connector provides all the functions of a network expansion card and supports the 10BASE-T, 100BASE-TX, and 1000BASE-TX Ethernet standards.

Each NIC is configured to automatically detect the speed and duplex mode of the network.

Regards,

~JG

Do rate helpful posts

1 REPLY

Re: Configure static ip routes on CS ACS-SE

Markus,

In acs you can only use one NIC and there is no way you can set static routes on it.

Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors. Each Ethernet connector provides all the functions of a network expansion card and supports the 10BASE-T, 100BASE-TX, and 1000BASE-TX Ethernet standards.

Each NIC is configured to automatically detect the speed and duplex mode of the network.

Regards,

~JG

Do rate helpful posts

149
Views
0
Helpful
1
Replies