Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring CAR 4.1 with EAP-TTLS

After the successful installation of the Cisco AR 4.1, we were able to verify open authentication using the "radclient". But when we started to configure AR with EAP-TTLS, we noticed that the only fields appearing under "eap-ttls-service" are

Name = eap-ttls

Description =

Type = eap-ttls

And it's missing something like 14 other parms including "AuthenticationService =" where the MSCHAPv2 is defined. Any thoughts?

Hazhir Afzali

1 REPLY

Re: Configuring CAR 4.1 with EAP-TTLS

Hello Hazhir,

how exactly are you configuring the service ? Have a look at the link below, are these the procedures you follow ?

Configuring EAP-TTLS

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cnsar/4_1/users/eap.htm#wp1042234

Regards,

GNT

121
Views
0
Helpful
1
Replies