Configuring Radius (AAA) on a Catalyst Express 500
I've tried to configure the Radius settings, the same way I did on a catalyst 3560 (using commands inside "http:/IP_Address/exec"), but for some reason, even after an authentication list is created the Switch fails to fall back to the next method in the list if the Radius server is unavailable. Has anyone had any success in configuring these Switches for Central Radius Authentication?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...