i am prepared to configure ACS Replication between my two SecureACS Servers vs 3.2. My question is, how am i supposed to configure both TACACS Servers in the configuration of let's say a router if the primary fails? As far as i know the IOS will accept only one "tacacs-server host 172.x.x.x" command.
just add another TACACS+ server below the first one. The router will always communicate with the first listed TACACS+ server in the list, as soon as the first one fails the router will try reaching the second TACACS+ server listed below.
the command for mentioning second TACACS+ server is same as you have mentioned above.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...