Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Controlling Access to devices using ACS

I am using ACS 3.2 and on the NAR section,I have used a wildcard (*) to define all the network devices on my network.All my users are in one group. However,I have just realised there is the need for me to create another group and put some users in that group so they only have access to some routers and switches and not all as define by the wildcard.

How do I achieve this goal.?

1 REPLY

Re: Controlling Access to devices using ACS

Under NAR select the Per Group Defined Network Access Restrictions.

Select the AAA clients you want the group to access.

Use the wildcard mask in the port and the address field.

You can also group the devices which you want to give access under a seperate NDG and in the NAR give permission to only this NDG for the group. In this way you may need not add individual AAA clients

HTH, rate if it does

Narayan

107
Views
0
Helpful
1
Replies