Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

critical vlan in low impact mode

Hello,

How is it possible managed a server radius failure when I'm using low impact mode and a port acl is applied ?

Is there a similar configuration like critical vlan used in high security mode ?

Regards,

Iarno

Sent from Cisco Technical Support iPad App

1 REPLY

critical vlan in low impact mode

Larno,

If you are still in low impact mode then you can leave the critical vlan as the same vlan as the access vlan then verify how the user was authorization by issuing a "show authentication sessions" command if you are going to place the users in a guest vlan or a vlan that has limited access then the port acl will only apply to the ingress traffic from the port not from any ACLs that exist on the L3 interface itself.

Thanks

Tarik Admani

Tarik Admani *Please rate helpful posts*
281
Views
0
Helpful
1
Replies
CreatePlease to create content