01-04-2007 11:09 PM - edited 03-10-2019 02:54 PM
Just purchased the above mentioned and i can't get into the appliance.
-Upon successful boot-up,i'm prompted with the "lock notice" capture asking me to either connect via serial or web.
-I've tried to console in the appliance using the provided serial cable but i just can't seem to get anything.It's just a blank screen.
Can someone pls pt me in the right direction?
Thanks!
01-06-2007 01:47 PM
Can you check the settings for the terminal software connected to the console.
The settings are :
.Baud = 115200
.Databits = 8
.Parity = N
.Stops = 1
.Flow control = None
01-10-2007 09:28 PM
That did it, i was using the old 9600 baud setting (i've used that for all of my cisco devices). This was one of the things i should have paid more attention to from the start.
thanks again!
01-11-2007 08:37 AM
cool...
rate me if it helped :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide