Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CSACSE-1113-K9 login problems

Just purchased the above mentioned and i can't get into the appliance.

-Upon successful boot-up,i'm prompted with the "lock notice" capture asking me to either connect via serial or web.

-I've tried to console in the appliance using the provided serial cable but i just can't seem to get anything.It's just a blank screen.

Can someone pls pt me in the right direction?

Thanks!

3 REPLIES
Cisco Employee

Re: CSACSE-1113-K9 login problems

Can you check the settings for the terminal software connected to the console.

The settings are :

.Baud = 115200

.Databits = 8

.Parity = N

.Stops = 1

.Flow control = None

New Member

Re: CSACSE-1113-K9 login problems

That did it, i was using the old 9600 baud setting (i've used that for all of my cisco devices). This was one of the things i should have paid more attention to from the start.

thanks again!

Cisco Employee

Re: CSACSE-1113-K9 login problems

cool...

rate me if it helped :)

407
Views
3
Helpful
3
Replies
CreatePlease login to create content