I have recently installed Cisco Secure Services Client to coonect to wireless network, which uses 802.1x authentication (EAP-FAST). Also i have ACS 4.1 in my network.
1) When i'm connecting to Guest1 (for example) SSID (there is no authentication) - everything goes right.
2) When i'm trying to connect to Guest2 SSID (there is authentication and pousture validation) i have this problem:
CSSC says that it is coonecting to the network, then asks me to enter my username and password, and then i can see small window from CTA on the screen (it says "healthy" - so it means, that my conputer passed authentication and posture validation), BUT CSSC still shows "connecting", and i've got CTA "healthy" window, popping up approximately every 15 seconds...then after about 5-6 attempts CSSC status changes to "disconnected". In the ACS "passed authentication" reports, i can see 5-6 strings (they were updated every 15 seconds), that says - authentication OK - but no connection was established. What could be the problem?
Thank you in advance and sorry for my poor english 8)
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...