03-02-2006 12:53 AM - edited 03-10-2019 02:29 PM
I want the network clients switch ports to be authenticated based on windows authentication. (801.x + ACS + Windows DC). Does any one have a documentation of implementing windows based network authentication?
Thanks,
yasemin.
03-02-2006 12:38 PM
Hi
There are several such docs kicking around on the cisco web. If you cant find them ask the TAC to email them to you.
Darran
03-03-2006 12:50 AM
Hi Darran,
i found them just after sending my message to the forum.
Thanks.
03-08-2006 10:42 AM
Yasemim,
Couold you please post the links? Thank you.
03-08-2006 11:02 PM
Hi,
The think that i was looking for is a specific case so, i found the domain user based network authentication configuration guide in the attached link. You can find switch level 802.1x config guides according to your hardware from cisco web site.
http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_user_guide_book09186a0080533dd8.html
hope this helps,
yasemin.
03-08-2006 10:43 AM
Yasemim,
Could you please post the links? Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: