Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dot1x Authentication

Hi, can anyone please tell me how to configure Cisco 2500 Switch so that it forwards the EAP requests sent by the NAD. I dont want the Cisco Switch to be the NAD but, it has to forward the Eap requests to clients.

1 REPLY

Re: Dot1x Authentication

Hello,

To my knowledge there is no Cisco 2500 switch. Are you sure about the device number? Could you please check and post again?

For 802.1x and EAP with Catalyst switches in general have a look at the configuration examples found f.e. in "Configuring 802.1X Port-Based Authentication" at

http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_chapter09186a00801f0a44.html

In case you have a router, have a look an the configuration examples in "VPN Access Control Using 802.1X Authentication" found at

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a008044cbc5.html

Hope this helps! Please rate all posts.

Regards, Martin

128
Views
0
Helpful
1
Replies