I have a question, I know that in Cisco Catalyst I can configure a dot1x guest vlan where the switch assigns clients to a guest VLAN when the switch does not receive a response to its EAP request/identity frame or when EAPOL packets are not sent by the client, or whith the authentication fails,. My question is that If i can do the same with a wireless network, with a WLC 4400??
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...